http://www.zmancustoms.com/images/TURNGRIPS2_1.gif[/IMG]Cool eh?? Sorry, I happened to see these earlier today then saw someone adking about...
[IMG]Cool eh?? Sorry, I happened to see these earlier today then saw someone adking about grips and I couldn't resist.
Xxxxxooooo
I always found this forum pretty mellow compared to others with the exception of a few over opinionated folks which is to be expected. I guess the...
Glad to help. I love it when something works.
Funny story. I wonder what Sheila looks like...
Good Deal! What I use is a 90 degree handle like you describe that has a 1/4 drive on the end. That and a 7mm socket (I believe that's the right...
A lot of forks have a large washer between the bushing and the seal. Set that on the bushing and push it in with the PVC.
Hi All, My firend just sent me this. I does have a good picture of Rossi_Stoner in the cork screw. Soup :: Laguna Seca MotoGP 2008 Race Photos
It's funny how that is with tools. I always justify by thinking "I've blown a hundred buck in worse ways than this". Having the right tool for the...
Well, the vac would be drawn from the cylinder and measured between the "butterfly valve" and the head right? If you open the throttle then vac...
You may be onto something now. The high vaccum would say that it's not open far enough as opposed to too far. Do you have the tools to do a carb...
The "pilot" screw are the low speed mixture screws in the bottom of the carb in front of the float bowl. They're for adjusting the air/fuel mix at...
If you mean the larger hole in the carb throat, that would be where the fuel is let in while using the enrichener circuit. If you rev the motor...
The slow jet and idle jet are one and the same and are removeable if my memory is correct. The passages between the throttle valve and the head...
I'm with Drewl. While you have it on the stand (rear wheel up) check for any lateral movement too due to worn bearings or something similar.
Hello, Two things come to mind. When your engine is running, vaccum is applied at the petcock opening the valve in the petcock. Can you get a...
Man, I thought I was going to have a good one there, but LGN is on the BALL!
Shoei RF1000 in RED. I like other helmets, but I have a Shoei shaped head...
You are one persistent guy! I for one commend you and wish you luck on your project.
Separate names with a comma.
