Another Regulator/Rectifier/Stator Question

Discussion in '3rd & 4th Generation 1990-1997' started by txst, Jun 30, 2023.

  1. txst

    txst New Member

    Country:
    United States
    Joined:
    Apr 25, 2018
    Messages:
    7
    Likes Received:
    3
    Trophy Points:
    3
    Location:
    Wichita, KS
    Map
    I am getting ready to upgrade the regulator/rectifier to an FH020AA on my 1990 VFR750F. My question is where do you tap into the stator wires? Before the plug on the right side of the frame under the gas tank (eliminate the factory plug and splice into the factory wires)? Or do you have to splice as close to the stator as possible?

    I have read many threads, but am unclear. Thanks in advance.
     
    txst, Jun 30, 2023


    This site may contain affiliate links for which VFRworld may be compensated
    #1
  2. Captain 80s

    Captain 80s Member

    Country:
    United States
    Joined:
    Apr 25, 2009
    Messages:
    7,489
    Likes Received:
    3,563
    Trophy Points:
    158
    Just go back far enough prior to any plug to get to good, non corroded or discolored wire. Solder them, do not use any connector on that run.
     
    Captain 80s, Jun 30, 2023


    This site may contain affiliate links for which VFRworld may be compensated
    #2
  3. txst

    txst New Member

    Country:
    United States
    Joined:
    Apr 25, 2018
    Messages:
    7
    Likes Received:
    3
    Trophy Points:
    3
    Location:
    Wichita, KS
    Map
    Your help is much appreciated.
     
    txst, Jun 30, 2023


    This site may contain affiliate links for which VFRworld may be compensated
    #3

Share This Page