3rd generation body parts for 4th?

Title basically sums it up. Can’t find any 4th gen fairings to fit my 95 but can find a few 3rd


Sent from my iPhone using Tapatalk

 

You want OEM? Good luck. Well... if you are handy at bodywork, you'll be fine!

Oh... maybe this is what you're asking: No. None of them will fit.

Time to think about body work / paint job. Or fiberglass reproductions.

 

Damn well I’ve been looking at buying this if I can find a decent cheap painter. https://www.motoxpricambi.com/us/ra...fairings-without-front-fender-mxpcrd3623.html


Sent from my iPhone using Tapatalk

 

I went the same route, except with Airtech-Streamlining RVF fairings. Not installed yet.

 

Have you received your fairings yet? How are there quality


Sent from my iPhone using Tapatalk

 

I do have the fairings. Received them about 4 weeks after order (about 6 months ago now....hmmm).
The quality is good. A very few small pits that would get just a pencil-point dab of bondo prior to paint (maybe a sandable primer would do it).
I'm happy with them and would order again. Customer service (phone call) was good.
What is holding me up is:
1) picking some 1/4 turn fasteners
2) finding the right size headlights (I'd like LED or projector, but with a 5-1/4" round lens

 

Maybe Amazon would have fasteners? The moto site I was looking on had the option to buy all the screws and what not you need but your stuck waiting awhile coming from over seas. If your gonna keep putting them off you mind as well sell them to me and save me some waiting time

I looked on airtech website and all there parts are the race ready ones? I assume you have to cut headlights out along with blinkers?


Sent from my iPhone using Tapatalk

 

The headlight (or any other) holes are not cut-out.
I think of it as 'a blank slate'; one could really modify it for anything.
So, yes, a bit of cutting and fab required for the headlights.
Many fasteners out there; just have to pick one.

 

I don't think they have the rear part but I got a front middle section off ebay. https://www.ebay.com/itm/HONDA-VFR-...722975?hash=item2595b90e5f:g:7PwAAOSwd4tUGoaj. Reasonably good quality, fiberglass. I think they only have the front section and side panels though.

 

Thanks for the link! All my searching and I couldn’t find that on eBay. Though they are a bit more then moto. I’ll probably just order from there and get the entire front half for 520 shipped. Anyone have any idea what it would cost to get them painted 1 tone?


Sent from my iPhone using Tapatalk