evap canister routing question

hi,
hoping someone can help wi a 2007 6th gen question - the larger hose connection on my fuel evap can is missing. The small one routs to the tank like it should, but I dont see where the larger one must have connected back into the throttle bodies or wherever. Theres no hose there at all to help figure it out ...

i dont see a "evap purge control valve" as on the CA models as shown in the manual pg 39 either...

or is mine the bottom diagram on that page that just has a hose going from tank to can and then one going out clipped next to the gas and water overflow? seems useless...

 

heres the page

 

I totally removed my evap canister a long time ago....

 

so it does nothing except in CA where its routed back into the throttle bodies?

 

I would reckon not, but I will let others chime in....

 

All 6th gen. models are the same. All are 50 state legal.
Large canister hose on the right runs to the evap purge control valve (which mounts to the middle 12mm engine frame bolt). If the purge control valve is missing then the canister is not functional (can be removed since the system no longer works). Hopefully the person that removed the purge control valve properly plugged the hose going to the throttle body 'T'.
The line to the canister can route over to the left side of the bike with the other tank drain line.

 

Thank you!

 

Route the whole assembly straight to the dumpster. Ha!

 

the first thing I did was junk this unit-one line from the gas tank is over flow for gas tank-that needs to vent-the other two is plugged.