New to the forum! New VF1000R owner too...

Here is a pic of the Mr. Turbo intake plenum, single throttle body, and injectors.

 

Here is what i came up with. GSXR750 throttle bodies, injectors. They look like they belong there don't they???

 

Ok, those are just too big. I'll not post anymore til i can figure out how to resize them...

 

I think these are smaller. This is me at the PMRA race. Ran a 9.39 @ 143mph on this pass. 1.48 60'.

 

Here is me taking my other bro-n-laws RC-51 for a spin after changing the chain/sprockets/air filter...

 

Lemme try that again...

 

The other pic's of the RC-51 were too big, sorry...

 

Here is a couple of pic's of my 1986 Thunderbird. .030" over 302, stk bottom end w/ arp rod bolts, TRW flat tops, Edelbrock RPM heads, Holley Systemax II intake, 36# injectors, 1 5/8" shortie headers, Dr. Gas X-pipe, full 2 1/2" over the axle, Ford F-303 roller cam, Crane roller rockers, Edelbrock gear drive timing set, Vortech S-trim supercharger, Tremec 5spd, Lakewood sfi scatter shield, Pro-5.0 shifter, 8.8" rear from a Mustang, 3.73 gears w/ powertrax locker. I think thats about it...