DIY Exhaust Install Instructions

Hello VFR's

I will be installing my first mod for my bike this weekend. I was wondering if anyone could refer me to any videos or instructions on installing my Leo Vince exhaust. Youtube did not have much. I have been searching this forum as well and have not found anything as of yet. Any assistance to save me time and frustration would be greatly appreciated.

 

Pretty bad instructions when I installed mine....just went by the pictures in the box...pretty straight forward...good luck

 

I can install and test ride after the installation if you like. :courage:
Just make sure keep everything loose and all fit before tight them up.

 

Go to this thread post #7, I scanned the Leo Vince Instructions. To say they're bad is an understatement.

Link: 2006 Interceptor w/Leo Vince Question

What duccmann said just go by the picture.

 

Just when you have the whole system together. .have help holding the two pipes while you tighten everything down..especially the two exhaust cans when tightening clamps

 

Well..any progress?

 

All installed. Not too bad after I read one of the forums suggesting to remove the gasket that was attached to the pipe connected to the headers. She sounds sooo beastly now ! Just received my ProBike module as well. So the mods are coming along. Going to ride the bike first with the exhaust to check out the difference then I will install the Probike Module.

Thanks to all the VFR's in the community who helped get me to this point.

 

AWP34.....I'm shocked you still have the inserts in.....you really want to hear that puppy growl...take them out. They give you two allen bolts for the empty holes. I ran it for maybe 5 months w/o and it just started to get annoying loud.....runs better in my opinion with them in...looks great.