HELP!!! Just fitted Power commander V - bike won't start!!!

I have an 03 stock Vtec, just purchased PCV and installed fine including both oxygen sensors, I have the ground wire attached to the negative battery terminal.

The bike turns over but won't catch - after 2 - 3 goes the FI light comes on.

I've imported a stock 03 PCIII map via the power commander interface and successfully sent the map to the PCV unit.

Any ideas?

Thanks in advance!

 

I would run through all the connections again and make sure all of them are secure. It sounds like the circuit is not being completed.
The only time my power commander wouldn't let me start was when the quickshifter was armed or there was a loose connection.

 

Why not run the stock PCV map instead?