Question about replacing the R/R, do you have to rewire the iginition switch?

Discussion in '6th Generation 2002-2013' started by judobrian, Sep 19, 2012.

  1. judobrian

    judobrian New Member

    Country:
    United States
    Joined:
    Sep 8, 2012
    Messages:
    69
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    Colorado
    Map
    The manual shows the ignition switch wired into the harness for the R/R.

    If I replace my R/R with one from Roadstercycle-Index, since it only has 2 output wires will I need to rewire the ignition switch?

    Thanks!

    [​IMG]
     
    Last edited: Sep 11, 2013
    judobrian, Sep 19, 2012


    This site may contain affiliate links for which VFRworld may be compensated
    #1
  2. silverbullet132

    silverbullet132 New Member

    Joined:
    Nov 24, 2011
    Messages:
    280
    Likes Received:
    0
    Trophy Points:
    0
    No, the 2 output wires go straight to your battery. No re wire needed.

    Sent from my MB860 using Tapatalk 2
     
    silverbullet132, Sep 19, 2012


    This site may contain affiliate links for which VFRworld may be compensated
    #2
  3. judobrian

    judobrian New Member

    Country:
    United States
    Joined:
    Sep 8, 2012
    Messages:
    69
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    Colorado
    Map
    That is so bizarre they have it in the harness.

    You just tape the end of the harness up and leave it?
     
    judobrian, Sep 20, 2012


    This site may contain affiliate links for which VFRworld may be compensated
    #3
  4. silverbullet132

    silverbullet132 New Member

    Joined:
    Nov 24, 2011
    Messages:
    280
    Likes Received:
    0
    Trophy Points:
    0
    Yeah, seal it up the best you can.
     
    silverbullet132, Sep 20, 2012


    This site may contain affiliate links for which VFRworld may be compensated
    #4

Share This Page