Parting out 85 VF500 interceptor

any tabs left on that upper fairing?

 

I could use the center stand if it is in good working condition.Thanks. Mike.

 

I'm looking for the rear fairing and the rear turn signals and stems, rear brake rotor too. I'll give you $40 + shipping

 

I need a fuel tank too, what are you asking?

 

1bd85vf500 your pm is full. How much do you want for the starter switch assembly (right control assembly) ?? Also i might be in need of some valve springs as i think i have a weak/broken one... is that something your interested in stripping down and getting out or no? Let me know, im mostly just concerned with the right handlebar switch assembly right now though. Thanks!

-Bob

 

Are the Ignition Control Modules available? If so, how much? I'm not 100% sure I need these, but I wouldn't mind knowing that some are available.

 

I need two turn signals (front set or rear set) might possibly purchase all 4 if you have them
two bolts that bolt fender to front forks
two bolts/nuts off of the windscreen

How much for all this not including shipping?

pm me when you can...


Thanks

 

How much for the carbs? Or will you sell me some of the springs that are on them?

Please pm asap. Thank you

 

Is the pulse generator still available? My other deal for one fell through. Please PM with pricing. Thanks.

 

how much for the fuel pump to 13143 and would it work for a 1986 vfr700 thanks.

 

Hi i am new to this forum and i just picked up a 85 vf500 interceptor. I am looking for carbs, a seat, and a top fairing. Do you have any of these left? My zip is 54017. Thanks

 

Hi all. I am a proud new owner of a 85 interceptor. I am looking for a set of carbs, a seat, and a upper fairing. Do you have any of these parts left and what you want for them. My zip is 54017. Thanks

 

Hi you email me last week and I am interested in the carbs and Tank and seat if you still have them. I would like to see a picture of the seat. I have been considering just putting on a new cover. My foam is in great condition but I would rather put an original back on it. I also need the lower fork legs but I will buy the whole forks if you don't want to part them separately. Please send me another email so I can get this rocket back on the road.

Thanks

 

You have any of the clamps for the carb boots left? I'm looking for at least 4.
Thanks.

 

Any chance I could get the lower crankcase from you? I need it to replace mine that is cracked on the stator cover mounting area. Thanks. Chris

 

what is left on this bike?

 

I really need a gas cap....getting all the locks as a matching set would be great.

 

You would need both halves fo rit to work as they are machined as a set. the only way to get out of that would be to have the main bearing journals line-bored.

I would like to know what is left as well! I could use some exhaust valves!

 

Hey not to jack the thread but arent these engine blocks made on an assembly line? Im asking because wouldnt they all have the same specs and tolerances including machining done? Thank you.

 

^^^ What they said. You cannot just replace the lower case half. Well, I guess you could, but the results would probably not be as good as you expect!