I am building a custom bike and I am using the VF1000R engine. I am getting ready to fabricate the engine mounts and get the engine centered in the frame. I need to know if the two lower engine mounts on the right side of the engine have spacers between the engine and frame or just a thin washer?...or no washers. I have all the stock engine mount bolts but I cannot tell from the OEM parts diagram where the spacers are located because the OEM drawing is not very well drawn. I figure if I get the mount spacers right on the right side of the engine then I can figure out the others on my own.
I am building the frame. The frame will be the same width inside as the stock frame but will have round tubing. The tubes will be slightly thicker. Square tubing is 16% stronger than round tubing.
