B.C. Licence Plate (Canada)

Hi there does any one know if a BC plate will fit in between the pipes with a Fender Eliminator Kit, Im not crazy about the stock setup:crazy:

 

will not. :frown:

Not even sideways I think.

 

B.C. Plate

I didnt think so,Ive seen a few done,none of them local ,smaller plates i presume,I dont mind what you have done (if its your bike) its the stock one that does not appeal to me at all....Mark Or Is yours Stock

 

Yep it's stock Mark, I think the extra brake light I have in the middle breaks it up a bit. Plus in the picture you can't see all the plastic and reflector hanging under the plate. That can all be cut off though.

 

If you move it back in about 6-8 inches it will fit as the pipes get further apart..I did it, problem being the tire then eats it when u hit a bump..

 

i was originally going to use a fender eliminator but i just wound up removing the big-ass plastic fender from the back, and left the licence plate holder in. cleans it up a lot.