Chain Waxing Made Easy - 101

Discussion in 'Mechanics Garage' started by Wabbit1961, Apr 5, 2008.

  1. whenindoubt01

    whenindoubt01 New Member

    Joined:
    Jun 28, 2008
    Messages:
    130
    Likes Received:
    0
    Trophy Points:
    0
    Funny thread. If you don't feel safe oiling your chain with the engine on and in first gear with the center stand down, than don't do it! If you are comfortable and feel confident about it, than do it.
    Thanks for this thread, I will keep my chain clean from dirt and my bike clean from over spray.
     


    This site may contain affiliate links for which VFRworld may be compensated
    #41
  2. Mainjet

    Mainjet New Member

    Country:
    United States
    Joined:
    Jan 5, 2008
    Messages:
    161
    Likes Received:
    4
    Trophy Points:
    18
    Location:
    Southern Ca.
    Map
    I tried this method & was very pleased. It is very easy to control the chain speed with the clutch. A job that normally takes 5-10 mins was done in 15 seconds.
     


    This site may contain affiliate links for which VFRworld may be compensated
    #42
  3. whenindoubt01

    whenindoubt01 New Member

    Joined:
    Jun 28, 2008
    Messages:
    130
    Likes Received:
    0
    Trophy Points:
    0
    My chain is waxed and clean!
    Thanks
     


    This site may contain affiliate links for which VFRworld may be compensated
    #43
  4. whiteboyslo

    whiteboyslo New Member

    Joined:
    Nov 18, 2007
    Messages:
    74
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    San Diego, CA
    Map
    wow. such a heated debate over something so trivial.

    myself, i just throw the bike on the centerstand, put it in neutral, and spray the wax from the backside while i spin the wheel with my hand. i do this about twice a week after my commute home from work (about 65 miles one-way).

    Mike
     


    This site may contain affiliate links for which VFRworld may be compensated
    #44
  5. GreyVF750F

    GreyVF750F Member

    Country:
    United States
    Joined:
    Jul 15, 2008
    Messages:
    3,267
    Likes Received:
    2
    Trophy Points:
    51
    Location:
    West of Cleveland Ohio
    Map
    Being out of the current day motorcycles/motorcycling groups. I didn't know there was chain wax. This post brought back memories of what we would do with our 24hr bike chains, before O-rings. We would take paraffin wax, melt it in a pan on the stove then drop the chain in it. Simmer for 30 minutes and viola the chain was coated all the way thru between rollers and pins. It really made the chain wear less and less adjustments during the race. Of coarse you wouldn't do that with an O-ring chain.

    I would never use WD40 for a chain. It may dispel water, but it has no real lubrication strength between sprocket and rollers. I use PJ1 or the alike for my O-ring chains and the last one lasted 15k miles before replacing due to rust from letting the bike set for several years without lube on it. Sprockets were still like new. I matched them up with new OEM ones and was amazed how great they were.
     


    This site may contain affiliate links for which VFRworld may be compensated
    #45
  6. Michael D

    Michael D New Member

    Joined:
    Jul 13, 2008
    Messages:
    105
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Phoenix, AZ
    Thanks Wabbit. For the last 25 years I have owned shaft-drive bikes so I needed a primer on doing this properly. Your system works great and I still have all my fingers.

    'Course you should have moron-proofed your instructions for people like me with the following addition:

    If-you-need-to-spray-more-lube-on-remember-to-put-the-cardboard-back-in-place!! Had a fine mess to to clean up on a hot bike.
     


    This site may contain affiliate links for which VFRworld may be compensated
    #46
  7. klee27x

    klee27x New Member

    Country:
    United States
    Joined:
    May 31, 2007
    Messages:
    138
    Likes Received:
    0
    Trophy Points:
    16
    Sure, there's some needless risk involved with the Wabbit method. There are safer, but slower alternatives. Funny, you could argue the same things about riding a motorcycle, to begin with. :)
     


    This site may contain affiliate links for which VFRworld may be compensated
    #47
Related Topics

Share This Page