help with no spark

Hi all
can any of you out there please point me in the right direction on what else to check this is what i`ve done so far.
1 - redone new leads got continuity but not with the little resistor in it is this right or should there be continuity.???????

2 - checked coils as per manual all seems to be good.

i have power going in to the coils but seems nothing coming out should i get power when i disconnect the spark plug wire and test it with a test lite.?????
any help would be great.
Thanks in advance
Dave

 

Hey

With no resistor then it should be 0,0 ohm.Have you mesured the coils should be around 7 ohm were the wires from spark unit connect/pulse genators should be 490 ohms when engine is hot/Resistors for the spark plugs think that it should be around 5 kohm not sure and if every thing checks out okay.Then you need to check spark units remember spark unit 1&3 controls spark unit 2&4.Tell me one thing does your rpm meter act funny when you try to start it.This is just what I try to remember since I work on my bike while ago so check the mesurement in the book also.

Best regards

Gunnar

 

If my last forum doesn´t work or you don´t understand

Hey

Check this website it help me allot.http://users.rcn.com/kochc/moto/spark/ig_repair.html
Hope this helps

Best regards

Gunnar

 

Check this website it help me allot.http://users.rcn.com/kochc/moto/spark/ig_repair.html
Hope this helps

Best regards

Gunnar


he set this to me help out alot .

 

Thank`s to all for all youre help i dont have time this weekend to do any thing but monday i will. So until then i`ll do a lot of reading so i am ready.
Thanks again to all i`ll keep you posted.
Dave

 

Check that with key on you get power to CDI unit........a naughty mouse or other rodent could have nibbled a wire over the winter....

 

Or a squirrel.Hehehe

Best regards

Gunnar

 

he might have NUTS in the exhaust system. :>

 

just a post to let you know how the bike is coming along. So i check all the relay`s that would send power to the spark units & every thing was ok so staret to check wires for the units all ok until my work partner was looking at the wires coming from the stator & one wire was burnt fixed that & got spark then ran fuel to the carb`s got it going but is pissing out gas took carb`s out again found out one of the carb tubes was bust the i also busted one so of to find some tubes.
Thank`s again for your help
Dave