fairing question and request

I am starting the final reassembly of my '92 and have a question and a request. Does the front fairing trim piece that mounts in front of the main plastic sit inside or outside the mid panel edge. It will fit either way. I have a small black plastic piece that says air intake shroud that came off the bike but darned if I can figure out where it goes. Also, even though I rebuilt both mid panels the left panel was really trashed, (I had to make fiberglass sections for the entire top rail), so if any member has a left mid that is all there and repairable i.e. road rash, cracks, missing tabs are ok I sure would like a chance at acquiring it. Pretty good with bodywork and plastic repair but my old panel may not stand up too long with all the appended bits I had to hand make. And finally, where might I find a picture of an European spec 92 for correct decal placement and type? Thanks
-Lee

 

fellow 92

Lee,

below are links to two manuals which may be helpful to you and others. Section 2 of the shop manual in particular.

Send big files the easy way. Files too large for email attachments? No problem!

Send big files the easy way. Files too large for email attachments? No problem!

As far as your fairing questions, I skim ebay and have a running search on for fairings, they do come up, but a new alternative is:
HONDA VFR750 1990-93, VFR 750 fairings, bodywork, fairing, upper, lower, mid, seat side, race, street, fender, tail, undertail, tank