Signs likely point to leaky or not adjusted correctly floats if plugs are wet and black and it only runs 15 seconds. Check for sparks on all 4 to...
That's right ! In ambient temps below 40 F, i tape over the oil cooler, only way to get it into the proper range of 180-195F.
You did the oil test to determine if rings or valves are at fault ?? Learned my lesson long ago, and i'll never buy a bike without making a...
That method usually works, but if it doesn't, you can use a large syringe to inject fluid into the bottom bleeder. (Reverse bleed.) It usually...
Unwise to proceed until you've studied the FSM.
Whoa, there, Bunky ! Compression should be tested with engine at operating temp and with throttle held wide open, right ?? With and without 1/4...
Thanks for the help, lads. :loyal: I'll take photos when i get the board out of the box.
Those bikes won't run right at 40F below, Gordy, and you've depressed me even more by causing worry and discomfort, thinking Honda might build...
I'm expecting to do any necessary repair myself, just soldering in a new component or two........if they're obviously burned or melted. If not,...
No, i won't accept that !! It's a great feeling of confidence (not to mention manliness) to be able to get your bike up by yourself, anytime. It...
Please dare to mention what oil you chose, and be prepared to defend that choice over hundreds of riders offering better advice............ :nelson:
Battery could be brand new but getting weak due to charging system problems. If new plugs don't help, begin studying cold-start troubleshooting...
Not easy on my old computa, Larry. My C-disk and other stuff goes crazy if i present too much info for processing, why i hope someone can simply...
Lets get some factual, scientifik info on the forum here: It's easy to remove the end cover on the box, and the board IS NOT POTTED WITH GOO !!...
Probably it's your battery on its way South. But new plugs should help a little. Plug replacement is covered in the FSM. Some models may require...
Learned a hard lesson ?? I'd NEVER ride off on a just-bought HONDA bike without first testing that it has at least 13.5 volts across the battery...
I need to get the circuit board out of its box on my gen2 to attempt a repair. (No spark on one cylinder.) Won't budge. I tried search, no luck,...
Trying to get 4th gen right hand side PCV valve installed properly after removal, and it's confusing. Pages showing pollution control valves...
Klutch slippage, i suspect, wasn't designed to handle that.
Gotta be more !
Separate names with a comma.
