MY favorite appearance of a squirrel in a Hollywood movie was the scene in "It's A Wonderful Life" where a despairing Uncle Billy's pet squirrel...
WHAT YA mean like what a damn mouse left in my muffler?? [IMG]
PRESS HERE << to see revealing photos of Kim Campbell stepping from the shower !! She's not a real blonde ! <<<<<<<<>>>>>>> FOR SALE:...
" NO jet should be considered clean unless you can put a thin wire through it." ( I do know this might border on the heretical in some places,...
ANY carbs you might purchase would most likely need a thorougth cleaning to start with and possible adjustments to tune it to your exhaust. AS...
THE slots around the basket normally get dented during use, develop notches and can hang up plate movement if worn too badly. IF that's the...
IF the clutch lever is bumping try rotating the holder up or down if possible.....or sliding it along the bar.
Welcome Too bad your bike is so new, it will be years before you need to to work on it...... try to avoid the QEW and any road that starts...
That's a really good shot....and shows a healthy disregard for snow.
Your problem could be hydraulic or mechanical. Can you shift to neutral easily from 2nd gear? Will the engine rev up but not pull any...
I never saw a black seat on an '86, but the '87 F2 had a light grey seat......
You need to be sure that the plugs in the engine are EXACTLY what the owner's manual specifies. = If your air filter is dirty replace it....
"SOME TUNING MAY BE REQUIRED" should be a black box warning with jetkits. 90% of the time you can follow the recommended settings, but not...
Check your battery voltage......
SORRY, who died ??
Good for you for showing some rodent respect, they're mostly misunderstood..... [IMG]
IN your dreams, mate.......
Probably not a full system (very rare) but using Yosh can on stock stainless headers ????? Yosh IS loud but maybe it needs a re-pack with...
Not a good idea......Dot 4 changed every 2 years is fine, no real need for anything else.
What is total mileage on the bike ?? Compression test first, then a good carb synch might be all you need. when you say valve job, you mean...
Separate names with a comma.
