https://www.vfrdiscussion.com/index.php?/forums/topic/72503-fuel-gauge-drops-to-empty-gas-tank-still-full-thoughts-ideas/ Service manual has...
24000 miles is about done for chain Sent from my SM-N950U using Tapatalk
How many miles on the chain? Tightening the pinch bolt to proper spec? Sent from my SM-N950U using Tapatalk
I would try a good hydraulic bleed first. Won't hurt any. If you open the oil filler BIKE OFF and squeeze the clutch lever, you should be able...
Gotta love the Honda special bolts [emoji4] Sent from my SM-N950U using Tapatalk
I know right?! I thought for sure I was gonna break mine Sent from my SM-N950U using Tapatalk
Fuses are up in the cowl on both sides. I think there's 2 socket head screws holding the funny looking panels in Sent from my SM-N950U using Tapatalk
Does the bolt go through the engine and frame? Maybe there's a nut on the other side Nm I just saw which bolt it is on the fiche It's a hex...
Are those 12-point sockets? Might have a thinner wall or may be a standard bolt in there Sent from my SM-N950U using Tapatalk
Soooo much easier than an SV650. Be sure to change that gasket for the gas tank too. Sent from my SM-N950U using Tapatalk
I have to head up there sometime to order brake master and clutch master reservoir diaphragm seals, so maybe I could Inquire about what you're...
You are looking for the plastic cover piece on the rear cowl when the grab rails are removed, right? Partsnerd has served me well. Those plates...
I found the cover plates through my dealership. Around $15 IIRC. Even had the Pearl Spencer blue available Sent from my SM-N950U using Tapatalk
Weird. Did you get numbers from your compression check? Sent from my SM-N950U using Tapatalk
Have you pulled the plugs after trying to start to see if they are wet with fuel? Sent from my SM-N950U using Tapatalk
Is the battery good? Like 12.6v and up? Is the fuel pump priming when you turn the key? You could clean up all grounds and battery connections....
The charging system is the weak point in these Hondas. I would check your stator output and r/r function. As always, with a new to you bike, the...
Hopefully a hydraulic bleed is all it needs. Thank you for your service! Sent from my SM-N950U using Tapatalk
Draining it completely will make it Really difficult to get a good fill. I suggest trying a bleed at the slave cylinder and see what the fluid...
Have you tried bleeding the slave cylinder for the clutch pushrod? Guessing clutch plates sticky or clutch hydraulics have air bubbles Sent from...
Separate names with a comma.
