I suspect more tuning than a PC was done to get 18 horsepower.
Politics and religion are so controversial, no winning very many debates. Especially when it is so polarized. Nice to hear all your complaints,...
Great job. Yep, ride it some more. 'Tis the season to be jolly!
I do not understand why one would need a PC on a 5th Gen. Is it just trendy to do so or does it actually solve some perceived fueling problem?...
Hang in, he's on the way. Have a good Christmas everyone.... I'll be into the egg nog too. [ATTACH]
I'll just add that sitting for 3 weeks with ethanol fuel in it may result in a few tablespoons of water in the bottom of the tank. Seafoam...
Before writing it off.... little story, buddy brings an '85 650 Nighthawk, runs on 3 cyl. Tested compression, a couple were like 30 psi, two...
You can always drop a Canadian quarter in the reservoir, it will prevent backsplash. Then you have a choice, leave it in there or fish it out...
Email sent.
Caution, that is for Rear Shock spring, and I can tell you from experience, RaceTech tends to be too hard for their shock springs. A better rear...
For your weight those springs are fine. You can always add some preload with the adjuster if need be, and if you run out of adjustment, just add...
Pretty nice, sir!!
What Terry says too.... I use a chop saw for the spacers, always square. Deburr, absolutely. I'd use straight rate springs, not progressive like...
Depending on the kit, they may provide you with some 1" dia aluminum tubing and some washers. Typical thing is to use some 1" dia PVC pipe, EZ...
Absolutely. 30mm is nothing. RaceTech, and I suspect others will have instructions on how to calculate the new spacer length and a certain...
You do not have to match the length, the only difference is the total length plus the length of the spacer you need. You can go a bit shorter...
On another forum, we have an annual Ontario event, and held it in Calabogie for 2017. One of the attendees knows the track manager personally and...
Bake your seat cover in the sun or otherwise, it will go much better....... a pneumatic stapler and a helper would be good too.
Yes please do, I am interested as well.
I worked with a guy in his 40's back in the 70's. He had a career in an auto body shop, constantly exposed to solvents and paint, and he had...
Separate names with a comma.
