Hell yeah.
Also explains why the bolt is going up in the schematic. [ATTACH]
Oh... yeah aftermarket headers too. Well, try to get the best seal you can. That's why somebody likely had the extra packing in there. I...
The only way the rear guide is gonna get into a position to ride against the chain is above the crank. As in mounted to the upper crankcase half....
Pulsar coils absolutely do fail, but are nearly always heat related when acting up and usually affect one bank. But certainly not impossible for...
If it's cranking, it's not the starter clutch. If the starter is spinning up and not "grabbing" or engaging the engine, that's a starter clutch....
Yep. You should loosen the clamps a bit to be easier on the gasket. I usually fully remove the muffler so as not to put stress on anything or...
Do you need new plugs perhaps? and do you have spark or not?
Unbolt and remove the halves and see what you got to work with. Either someone was trying to compensate for severely deteriorated parts, or they...
That wrap is not there as stock. The end of of the muffler is dished to match the shape of the gasket, and the 2 piece clamp when tightened (with...
Possible. 500 units are pretty damn resilient tho and bad ones usually aren't intermittent like you describe. Starting no problem to not at all?...
Also note that on the diagram the bolt for Guide A (rear, next to trans) is being installed from the bottom, up. Can a guide be mounted on the...
IF you have the correct parts, and it very much appears you do, then it is not the only way. Not trying to be a dick, it just is the truth or...
OOOOOOF!!!! It's not an Interceptor.
120 mile blast after work. Mt Rainier in the background outside of Carnation. [ATTACH] Over the ridge and back, now on the other side of...
Good. Just one tank for sixdog. More space for me.
Yeah!! What they said. And, hey guys, the trailer will be empty on the way up, so don't forget all the bodywork that we are dropping off too!
I think you have the one in your hand mounted upside down / backwards. In the schematic, Guide A grooves are facing the transmission. Both...
I was doing some organizing in the outer shop last night, and I might have some cases I can look at this weekend.
Ahhhh... got it! I might look for the Vesrah on my next application and give them a whirl. And the Honda pads for the 500 actually appear to...
Separate names with a comma.
