Crap, the Magna V30 engine I bought has only 70 PSI of compression. Can't seem to get a break here.
Oh and I ended up buying another bike....1985 VF500C Magna....I ended up paying $300.00 for it. I think it was in the 2017 flood here in Houston...
UPDATE....I got my cylinder leak down tester in and put it to work. According to it my compression is "OK" at abut 30% leakage. Am I reading...
https://www.ebay.com/itm/For-Toyota-Honda-VW-Audi-Motorcycle-Car-Valve-Spring-Compressor-Pusher-Tool-/332906265940
Are those acorns? Pretty industries rodent at work there!
Good advice, I am sure thinking that right now. I have no idea who can do a valve job here in Houston however. I don't want these to be a...
Yes lapped the valves but not confident they don't leak after the engine gets hot. Yes, it starts smoking after about 5 minutes. Compression is...
CHARACTER BUILDING! So the engine is installed and actually fired up almost instantly. GOOD NEWS. However.......nothing has changed as far as...
Ye Yeah, trying not to think about it too much! That is a pretty complicated engine. Lots to go wrong.
Nice progress! Like that solo seat.
Engine finally done! Got it installed today and hope to have it running this weekend! Finally got the workbench cleared after a month of waiting...
It looks like I got the timing right, adjusted the valves and nothing crashed as I turned it over several times by hand. YAY! Just need to get my...
Thank you! I just registered for that site. It would not let me view the link without a registration.
[ATTACH] [ATTACH] More progress! Got the cams timed. Still sweating it out as this is something you CANNOT get wrong. Rolled it over several...
Thanks! I had another set of eyes look at it and it appears the "Dark" or non-silver ring was the bevel cut. The bevel was so subtle as to be...
Awesome! It is not too hard if you have an OEM Manual. At least you will be able to get parts a lot easier than on this '86. Nothing comes easy...
Made some big progress today. Had to stop because the gasket kit from Japan did not come with the oil pump orings!!! Another order to...
I have taken several close ups and I cannot tell. Hate to get this wrong.
Need some advice again. I am installing the rings on the pistons and cannot figure out which ring goes in the 1st and 2nd ring groove. I...
I have to agree with your friend on that. It seems to be silicone. I wish Threebond was more readily available around here, I think I will go...
Separate names with a comma.
