:tongue: - Already did !
Wheel spins fine with no drag calipers removed ! :smile:
Spacers are in correct, if they wernt then one of the rotors would catch on the fork leg. Took the master cylinder off, stripped it and cleaned...
Ok so I have done the sync with the normal vacuum gauges. Worked like a bomb. So to begin with it wasnt really off that much...only the one...
Right, Had a look today, axle was a bit more in than the norm but did not change anything. So I too the calipers off again, made the...
Thanks for the replies Arno(again) and vfr rider ! I have checked the no11 pins on the caliper and yes they can be at fault if they are dirty...
Ye ! I bled all the lines which was faultless anyway... 1. Front calipers 2. Rear caliper 3. Midway valve under the seat 4. Boost cylinder on...
Thanks for the info Arno, It will be of great help in the near future ! Cheers
Not a problem mate, She's a 04 and the pads are Ferodo... I think everyone is still on hols !
Elwray, no I did not. I did not feel that I needed to because they look like new. There are no dirt there and every time I took the calipers...
How much was the kit Stoshmonster ?
Hi all, Had a read here : My Go At Starter Valve Synchronization - Lots Of Pics - VFR Discussion and thought mine should be checked. Now I...
Hello everyone, I recently replaced front pads and had the rear done about 2000Kms ago. What I noticed is that the front calipers do not...
Thanks for that anikamnkar , Yeah I know the fitting will be the same but I was talking about the three tabs on the actual bulb...normally the...
OK so does this car kit allow you to convert the High and Low beam ? Also, did you have to modify your bulb sockets on the headlight ? Normally...
Separate names with a comma.
