Reading thru the comments of another thread it was pointed out that there are a couple high points in the brake line plumbing on the 8th gen - I...
SubyRS: Yes, I've had a similar issue on my 2014 Deluxe when I ride to work and the bike sits in the sun all day - The front brake feels very...
Depends on how much you ride - I normally go with a 530 chain, I've found they tend to last a little bit longer than a 520 and its a messy job...
I rechecked my valves at 143k miles this weekend, previous check was at 43k mentioned above. All four normal exhaust valves tightened 0.0005” or...
I know it isn't necessarily recommended in the manual, but I normally pull the valve covers off and do a quick check the normal valves first. If...
I checked mine at 43k miles: All four exhaust valves were tight, particularly the rear two cylinders. The VTEC lifter in #1 exhaust was right at...
1122141700 - Copy by SlideRule posted Mar 12, 2019 at 9:21 AM Turn Signal Relay highlighted in yellow, the connector you need to access is...
Self Cancelling Indicators Disable
I posted on the other site, but for reference: Clipping the Pink/Green & Pink/Blue (Speed Sensor Wires) or removing them from the connector will...
I replaced my first chain on the 8th gen at around 20k miles with a DID 530 set, as I needed it right away and sprocketcenter had 6th gen sets in...
Yes, your foot position does change slightly after installing the quick shifter due to that little fin or block plate - It feels like your toes...
I checked my valves in my 8th gen at 43k miles - all four normal exhaust valves were too tight, particularly the rear cylinders. One rear VTEC...
I had an '03 6th gen, '08 6th gen and currently have a '14 8th gen. The VTEC kick was most noticeable in the early ones, getting smoother over...
I did all three well over a year ago - no notable performance increase nor decrease, although the intake noise is a bit louder after the airbox...
So far my 2014 is proving to be more reliable than my previous VFR's with cheaper maintenance costs to boot! Over 50k miles and going great!!! I...
If the clutch plates are dragging a little, wouldn't an easy test be to engage/disengage the clutch at idle? If that were the case, wouldn't the...
I plasti-dipped the same lower panel right after I bought it; thought it would look better breaking up the monotony. I did plasti-dip in case I...
My buddy had the same problem after we re-assembled his CBR after sliding down the highway. The bank-angle sensor was loose and would kill the...
Flipping the lever end-for-end wouldn't make a difference. Stock configuration: QS linkage is in compression on upshifts which activates the cut....
38,000 miles & snapped a pic this morning to prove it: [ATTACH]
Separate names with a comma.
