am assuming your bike is a 6th gen VFR. what model Hyperpro did you install? Does it have a mounted separate reservoir or is it built into the...
after some research i am now in between a Penske and an ELKA rear suspension upgrade. any feedback on these? The ELKA i know are from Canada and I...
when selecting the spring rates do I use my weight or the sum of my weight and the passenger + luggage or an average?? thanks
I want to refresh the suspension on my 2003 VFR800 with 30,000 miles. Most of my riding is sport touring and 50% of the time I am with a...
I finally installed the heli bars and all i can. Say is What a difference!!!! I found them online here Honda VFR Interceptor seats, luggage, bars,...
Can some one point me in the right direction as to where to buy the heli bars online? I am also going to buy new dampener. How much are the damper...
ahhh, ok. It thought that when the bike is on the center stand and in 1st gear, if I pressed on the clutch lever, the rear wheel should move...
I did that last night at least 3 times and every time the clutch ended up with the same pressure. Dont get me wrong, I do have some pressure on...
ok, the only thing that worked for me was during the bleeding process was to use a syringe to push the brake fluid backwards (from bleeder screw...
ok, the only thing that worked for me was to use a syringe to push the brake fluid backwards (from bleeder screw to reservoir) and voila!!! That...
i shoved that thing in there and the clutch cover is on!!!!!!!!!!! now I need to figure out how to bleed the clutch as I just added brake fluid...
thing is that last night I open the bleeder and pushed inward on the piston and nothing, it wouldnt move. I didnt want to apply more pressure as i...
thanks!!!! FINALLY someone responded!!! I am really frustrated with this DYI, I was so pissed last night as I could not figure out how to get...
Ok after researching nag going over what I did last night, I think I might have presed on the clutch lever when putting the bike on the center...
OK, I took off the cover on the sproket side to replace sprocket and chain, got it all back on and the cover will not go on. There is a long pin...
I think the part I am talking about its called the Rod Clutch Lifter, #15 on the diagram on the link below...
ok, I just replaced both sprockets and chain on my 2003 VFR but in the process I seemed to have moved the pin that goes thru the transmission....
well, it is still happening. I took some slack of the throtle hoping it will fix the issue but it is still shuting off when shiftin from 3rd to...
thanks, can you tell me more about the emissions stuff and pair valve delete. if you have a how to that will be appreciated.
ok, lets explain, let say I am going in 3rd gear down the road and i need to make a right hand turn next. so i slow down, hit the brakes, pull...
Separate names with a comma.
