Much better, very easy turn in and very stable in the corners. Only woe is the kickstand and the sticky clutch when its cold, but for a 28 year...
its higher then factory for sure, i had to remove my center stand because it was a half inch off the ground.
I think I need to make the kick stand longer... It leans over too far imo, will another type of kick stand from honda fit? any ideas?
looks great, keep up the good work!
Thanks, I adjusted the valve lash and synced the carbs last september. I changed the oil right before I put it away with moble1 and a fram...
finally got some pictures of the final product, i think I may flush the brake fluid before I start driving it for the season but its ready to go...
cool project for $250, good luck!
f4 shock was used. I checked out your thread on the f2 swap, and with your calc on stock diameter tires you still calced 27 rake but 100mm of...
Everything is back together and work well. The daugherty motorsports shock fit fine but it raised the rear up quite a bit. Enough in fact that the...
Yea, I know a guy there and he does all my work I can't handle. I considered buying my own tire mounting equipment and balancing tools but i...
got some work done this weekend, got the forks sealed up but i broke the c-clips in them so im on hold til I get new ones this week. Still waiting...
thanks for the advice guys! I'm going to attempt the forks this weekend. What type of solvent should be used to clean out the forks? A degreaser...
I ended up buying some all balls tapped steering head bearings after some advice from my honda shop. Ill prob need a spanner wrench to tighten it...
Hey guys, started my winter rebuild/tune up of my 1984 vf500f, already did plugs, coolant, oil, carb sync and i currently have bought chain,...
just hit 21k on my 84 vf500f!
so there is no adjustment on the chain tension its self? its just tensions on its own?
Good to hear, what kind of pads did you get with the pads? I just installed Goldfren ceramic carbon HH rated pads on the stock rotors and it stops...
the real scary part is i bet this guy in the truck doesn't think hes done anything wrong... I bet you get went home and was like," these biker...
stuck slides in the carbs? open up the air box and look into the top of the carbs. the slides are the first thing in line, try to move them in and...
ahhh, this is the one id need. so i could get this one if there are 10 other peps willing to get one too at the same time? 22-0054 by Fast from...
Separate names with a comma.
