Was riding today and when I got back my headlight was out. I pulled the bulb and it looked fine. I plugged it back in and hit the starter and it...
I cleaned the gallery a little bit. Used water, a piece of welding wire, compressed air, and a shop vac. Poured water in from the thermostat side...
With a little bit of prying and convincing I got the seat to fall in place but only have one bolt to lock it in with. Going to try and flush the...
I pulled the carbs and cleaned all the mess from the stainless pipe. Thermometer broke so I cant tell if it helped. It took about 3 liters of...
Could you look at a diagram for my bike and confirm which direction that the water flows through the system?
It only shows two in the service manual. I think taking the carbs and oil lines off will be a pain. I think there's probably something that can be...
Almost finished with my dads '85 VF1000R after sitting for 15 years. We just did basic fluid changes and a carb rebuild at the local honda shop....
It's been running for a couple of days now. It smokes pretty bad tho. It's not a coolant leak. We but grease on the boots when they went in. It...
My dad's 1985 vf1000r's rebulit carb was put back on today. We have it pretty much back in one piece. We went to start it up and so far it hasn't...
It can't look any worse than this bike. Here's what I've got to work with.
I jumped the harness and got power to the pump wire. Thanks alot. One more thing! I have a long hose that runs off of the carb. My dad tore most...
New to forum. Fixing up my dad's old Interceptor for fathers day. I have the carb at the local Honda shop being rebuilt while I figure out the...
Separate names with a comma.
