Grease location Here is where you put the grease. I just put a little dab on the end of the shaft and reinstalled the slave cylinder.
that sounds like the issue, I will tear the slave cylinder off and put a bit of grease on the end and see if it goes away. that sure would be nice...
I got some from my local honda dealer. Beaverton Honda in oregon. They came from a California warehouse. They said there were 18 available.
I think it might be this guy but I need to tear it apart... [ATTACH]
I just finishd rebuilding the rear head on my 86 vf500f and now that I have it back together the transmition or clutch is making a squeling sound....
http://www.bikebandit.com/1986-honda-interceptor-500-vf500f/o/m151673?a=1#sch544429 Does anybody have any experience making head gaskets for...
After imagining the valve dropping and the damage it will cause I have decided to replace the valve. Just a bit too scary for me... Can I pull...
Does anybody have the specs of the hardened caps that would go on the valve stems? I used to work as a toolmaker and still have access to the shop...
Thanks Jeremy, I may just do that, I am having a hard time finding head gaskets. I would hate to tear it open and not be able to put it back...
it is the rear, I found OEM valves on line. I have not opened up the front cylinders yet. would it be easier to pull the head with the engine...
how long do you think the valve would last if I just replaced the adjuster?
When you say replace all of them, what do you mean exactly? What usually gives first, the valve or the adjusting screw?
ugh... What would happen if I just replaced the tappet screw? I am not too excited about tearing the head off of this bike... I am surprised how...
I picked up an 86 vf500f that had been in storage for about 10 years. the bike has 32,000 miles on it and after a good carb cleaning, seemed to...
Separate names with a comma.
