The bolt is what is in place - and I have that. What I don't have is the retaining clip that is mounted to the lower cowl piece. From what I can...
I would have said a Dzus fastener also - but near as I can tell, the "clip" that the retaining "bolt" fits into has only two small "tangs" that...
I have a 1990 VFR that was in almost pristine condition. During a recent move, it slipped on the trailer and suffered some minor fairing damage -...
I looked at his information - that's where I found the diagram that makes me think they will work with this bike. I have asked for his advice....
As was evidenced by my previous effort, electricity is NOT my strong point. While chasing my previous problem, I took a good look at the bike's...
Finally got the time to chase this down - and found it to be a combination of a less than optimum connection in a crimp connector, a failing...
Thanks for all of the input. It will be the weekend before I get the time to pursue any further. And yes, I figure that while I've got her...
Some more info - battery connections are tight. While poking about, I must have done something because suddenly I had electrical functions again....
1990 VFR - I've had her since '95 and it has been a trouble free bike - a bit over 50,000 miles. I did burn the main electrical connector at the...
Appreciate the information - something for the relatively near future for my bike - not definite on the shock, but mine ('90) is definitely in...
You've obviously put a good bit of effort into getting this bracket "right." Any chance you have a drawing or measurements so we could perhaps...
I've used RKA soft luggage on my '90 and been very pleased with it. With some spray on treatment, they've been acceptably "water resistant" - and...
Jesse, Not an expert, but I'm just below Smyrna and have some experience with the VFR in particular and motorcycles in general - be glad to lend...
OK - I deserve that! Not familiar with the CCT acronym - and a search says it is too short a term to return results.
I don't mean to hijack this thread, but as it appears to have reached a conclusion, I would like to throw another issue into the discussion. This...
Separate names with a comma.
