Thank You! The ground to coil #4 was cut in half.
Well, shoot. #4 (front right cylinder) is not firing at all. I jumped the fuel pump and it primed the float bowls and it fired right up. I let it...
Well i decided to open up the drain screw on the left front carb and nothing but a dribble came out. Same with the rear left. Left the screws open...
Fuses are good. I may have fouled or flooded it not to mention it's cold today. Lower 50's. I'm going to let it set overnight and try again tomorrow.
I tipped my bike over in the garage. It ran perfect before that. I have been repairing the damaged plastics for the last couple of weeks. Thought...
Same here. Just got one and love it.
I was thinking of doing the bottom fairing piece that is already dull black on the 4th gen. Not sure if that stuff will hold up to the heat while...
I just put this on my '94. It still has the factory baffle in it and I must say it sounds great. It is smack in between a stock exhaust and the...
One thing to note about the carbs on the 4th gen; They are connected via metal shafts that run through the assembly. It is easy to remove the...
Buell has a clear tank, well, airbox cover actually, that i could see the single rubber v-stack inside of. Hmm, a honda v-four in a Buell XB...
8mm is correct. Once you have one set of bowls off the bottom screw is easy to get to with a phillips screwdriver. Make darn sure to return each...
I used to be a toolmaker. You have some talent! You have inspired me to learn to weld aluminum and make some too. Great job.
Piece of cake! Bike purrs now.
I've just finished cleaning and sync'd my carbs on my 94. The bike has only been in my stable for a week and it was much easier than my first...
Thanks for the reply Kennybobby. I seen the bolts in the schematic and was hoping but I can hope in one hand and poop in the other. You know which...
The PO lost one of the air tubes (velocity stacks) on the carbs. The only way to put another one on is to remove the plenum. If I leave the...
My favorite vfr so far. Good luck with the project!
I couldn't leave well enough alone so I cleaned the carbs the best I could, cleaned the jets and put everything back together sans the velocity...
Just got her home. 4450 miles on the odo.
I won't have time to clean and sync today but after some more inspection, it looks like they tried to remove the plenum first but gave up after...
Separate names with a comma.
