I got an led one on it...thats how i knew it went bad...i looked down saw 11.5 and turned around bolted home
Got one from a motorcycle salvage yard came off bike with 3700 miles on it
Got the R1 rectifier instaled yesterday works great Its showing 14.2 volts while riding and 13 at idle With the old rectifier it never got...
So this will work...
What about a R1 rectifier?
*The Super Mosfet Kit FH020AA
11.4 coming out of r/r at idle Doesn't go up with rpms stays at 11.4
Test at the green red wire coming out of r/r
Yes all 3
Ok..i had meter set wrong Now i get low 20s at idle and this at 3000 rpm or so
When these yellow wires are touched...one touched with black prong and one with red prong bike running i get zero volt reading
When i touch red prong to one yellow wire and the black prong to another with bike running . .i get no volt reading on the meter
So just touch black prong to one and the red to another?
No plug...all wires plug to r/r separate
Just unplug the yellow wires from the r/r? Or unhook them where the connector was ?
If the stator was dead and not putting out volts the yellow wires would not get hot...right
Like i said was charging fine yesterday And when i first took off today..it has a volt meter installed and was at 13.8...then i noticed while...
One of the yellow wires plug into rectifier gets hot with in 20 seconds of running u cant even hold it its so hot
Can i ck volts coming ot of stator at the 3 wires
The connector is gone the 3 yellow wires are hard wired It was charging fine just went out all of a sudden
Separate names with a comma.
