Armed with the knowledge that the solution lay with the slave cyninder I set about resovling the problem this morning. I removed the slave...
I'm sure I never touched the clutch lever. Tomorrow I will dismantle the slave cylinder to check if the piston is fully back. Failing that I...
The speedo sensor is removed and it fits without the rod. Thanks
Thanks, but as I push the rod back in I can feel it engage with the lifter piece by about 1/4 inch.
Thanks, I was hoping someone would know if I need to remove the pressure plate. AS I push the rod back in I can feel it engage with the lifter...
I can tell by the marking on the rod that it's fitted correctly and is a far in as it will go. I have no itention of forceing it. Looks like the...
Thanks for that but the rod seems to be as far back as it will go but it seems to be 1/4 inch too far out.
the clutch slave was never removed from the sprocket cover. I have measured the lifter rod and it is too long for the clutch slave by about 1/4 or...
I have just fitted a new chain and sprocket to my 2000 vfr800. I now find that the front sprocket cover will not seat properly. It looks like the...
Separate names with a comma.
