twowheelracer you would at least need the 12ohm ones idid not check if my ones get hot. i did not cut in to my turn signal wire`s from the bike i...
OK update ran the bike till hot ( 20 mins ) let her die results i found was no spark to back two cylinder`s which is 1 & 3 which also would...
ok my bad this is what happens ( reworded ) start the bike runs fine 20mins later the Tachometer dies as if it was unpluged bike still runs but...
Gunnar no my tachometer does not whack out on start up. i will be checking my spark today after the bike warms up to see if i`am getting spark...
Gunnar how do i test the pulse generator`s,?? is there a way to do this & what would i need. sorry i`am new to all sorts of testing electrical...
[ATTACH] [ATTACH] [ATTACH] Here are the pics, of how I wired my resistors.
also check the clips that hold the fuse they might need cleaning even if the fuse is ok it may not be getting a good connection. dmvfr where in...
you may also won`t to check the main fuse box & clean the terminals where the fuse clip in to. i had the same thing with my head light took 2...
Thank`s gunnarf06 checked fuil pump yesterday it is working fine going to check spark pug`s today if have time. but what is pluzzeling me is when...
twowheelracer what i did was cut the signal light wires. I cut one wire first then joined together & put a spade connector on it which fit on the...
hay twowheelracer i did this to my 83 vf750f i like the look they do still flash alittle faster but you do need two resistor`s one on each side my...
Thank`s a lot i have got an other pump i`ll try that i`ll keep you posted. Thank`s again TOE CUTTER & gh53821
Hay VFR family my 83 vf750 f runs for about 20 mins then the rpm needle drops to 0 then she dies but if i keep the revs up i can still ride but...
thanks to all for all your help.
toecutter what else do you need to know..? this is what i have done so far cleaned carbs but havenot done any thing to them ( ajusted ) all stock...
i have an 83 vf750f done afew things to get it running after it sat for a few years got it running the only proplem is ( onsaturday fired it up )...
just a post to let you know how the bike is coming along. So i check all the relay`s that would send power to the spark units & every thing was ok...
Thank`s to all for all youre help i dont have time this weekend to do any thing but monday i will. So until then i`ll do a lot of reading so i am...
Hi all can any of you out there please point me in the right direction on what else to check this is what i`ve done so far. 1 - redone new...
Thanks crey i started messing around with the leads today all i have todo is get the o-ring off then off to the parts store... Thanks again for...
Separate names with a comma.
