Rubber adapter made from anything by the hand, and big metal syringe. Or by measuring thread, buy or use old sensor. As I own workshop, anything I...
Low pressure switch, as I remember those engines had it
If you have this much seized engine, then better disassemble it. usually you can just start it with a little oil in cylinders for first time. No...
Mostly you can just start it. Best is as mentioned, rotate with wrench, oil in sump, and plugs out. Wait till new oil filter fills up, and oil...
Those tensioners do not need oil, trey are one way with thread/spring. This hole will not do anything, you have "key" to fix if before install....
Measure with amp clamp, you will see if battery gets charged or discharged...
Bad contact can make more heat, so overheat spiral in bulb. Measure voltage at different ride styles. On battery.
Always read manual, resistance is needed for "smother" spark, to filter sparkling noises. If OEM have resistance, buy alternative with same...
Once contacts are sanded, be ready to clean them in a while. Best to replace them.
disassemble, measure o-ring, buy for about 1dollar, replace...
Yes, good to check if voltage on running bike is ok, cheap test-when RR(rec/reg) is dead, and regulates voltage at too low level, or it "thinks"...
Needed fast reliable volt/temp meter. made from 2 nodemcu, works via bluetooth :D also programmable fan. Voltmeter from battery. For precise...
Hey, got stuck with my VT1100C, clutch diaphragm is dead, not available aftermarket or oem. But found out that VFR400 NC30 have similar...
Check for bad coils, similar gets when coil is shorting circuit. Best to check with scope. Had similar
Separate names with a comma.
