Well it doe's it at any gear i'm at and I see now I just need to downshift before turning point blank, I must have gotten myself in the habit...
I dont know why but when i'm downshifting in a turn the rear end seems to jump sidewayz its not a good feeling , the tire pressure is good and the...
thanks guys the guy on the blue bike did a fine job riding it in i may c how it feels and if it feels good do it otherwise with a friend or two...
I am about to and am overprotective about my bike I have no choice but to load it into a moving truck whats the best way to go about it i will cry...
sorry about this stupid post i real;ized its euros duh, but change of subject how ugy are those stretched bikes eeeew , its no better than...
i tried a currency converter but i coudnt find the right one on the thurn website it shows a sigh that looks like a C with lines but that dont...
i wish there was a more detailed diagram of the way the judder spring sits
well i can rule that out thank god because i was oh so carfull to not pull the clutch and i used the block of wood trick to be sure , so now which...
a small ball?? i dont remember one it seems like there uis a guide or something and then the bearings on the end of the rod, but what i need to...
i never planned on taking the judder spring out it came out with the bands so i didnt see which way it was facing :(
thenarrow one goes on first right???and which way is the judderspring suppose to face it says dish side in but i still cant tell please an idiot
also whats the difference in the (narrow)friction disk from the friction disks i didnt notice ant differences in taking them off
I have a manual and it seemed everything was ok i dont understand the judder spring/seat i think when i took the plates and disks off , the first...
So now i'm having a hard time getting it in to neutral and the clutch lets it start moving if realeased the tiniest bit
well i ithink i finally it , it seems to be getting better the more its shifted but the clutch lever doesnt give me much to work with right as...
isit also possible the springs could be tightened down to tight??i doubt it because when i tightened them down , i tightened them down all the way...
yes i did soak them in oil , is it possible i turned some kind of like drive gear or something because the gears dont seem right i cant go all the...
yes plates , springs , bolts are good ,the smallest sprocket thingy that spins to rotate the starter did fall off while trying to line up...
ok i fixed the no start problem it was the washer not on right , but now its like the clutch is dragging it starts in neutral but when i try to...
after final oil fill up i tried to start it , and it will click but not turn over.... any takers
Separate names with a comma.
