I did provide plenty of ventilation in the bags. I am mainly concerned with water splashing up and onto the wheels and underside of the bike. I...
Took my last ride of the season today. Beautiful sunny day here in Boise. On the cold side however but my gen 3 sure likes the cold air induction...
I removed a complete PAIR system from my '92 VFR750F. You can have it if you pay postage from Boise, Idaho. Otherwise it goes to the dump soon.
My gen3 petcock went TU and there are no new replacements to be found. I fabricated an adapter and installed an aftermarket petcock. It gives me...
Can you provide a data sheet? Typically for a 12V system the LEDs come three connected in series. You want to limit the current to about 250mA
The key is to use just enough to shine up the rubber without leaving an obvious film. Rub it in well and it should work just fine. BTW I don't run...
Going to the half mark is pretty good. I replaced my thermostat with a factory new one and it still runs a bit on the cold side. As long as your...
Check out this guide: 750 91 - 97 Carb Balance Guide Its on the vfrworld site. ;
Took my '92 out for a spin in Boise last evening. Temp was cool in the 40's F. A warm engine and cool intake air sure makes a good combo. The bike...
As you mentioned in a previous post, its like having a second job. It will be worth it however. You'll know your bike inside and out and you will...
Check the height of the fork tubes in the triple clamp as well. Raising the fork tubes in the triple clamp changes the rake angle and will make...
Doesn't sound particularly bad to me. The whine is the sound of the gear driven valve train which is classic for these engines. Also, it looks...
On the load bearing repairs I typically back the repair with ABS cement and light weight fiberglass for additional reenforcement. The project is...
GVCT, In my opinion you need to give the bike a thorough cleaning. Spray the entire bike with engine degreaser and then hit the carwash. Pull all...
I recently had my carbs apart to change main jets and reset the needles for higher altitude riding. The rubber diaphrams were in good shape and i...
The plastic is made of ABS. Ive used ABS cement with great success. The solvents effectively weld the broken pieces together. Ive even used it to...
Gotta work with watcha got.
Apply the choke while your riding. If it causes the engine to get real blubbery then your choke probably isnt stuck. How does the bike run at low,...
So, I've had my carbs off and on a number of times thereby requiring removal of my choke and throttle cables. When I adjust the cables for zero...
Thanks for the suggestion. Its beautiful here in Boise today so I took the bike for a spin. I was firmer with my shifts and the bike worked well....
Separate names with a comma.
