No, sold it last fall, sorry.
Here's photos of what I have Greg. The button was repaired by drilling through the axis of the button and a stiff wire inserted. I put a couple of...
I have a button that has been repaired, I'm sure it will work. Yours for the postage.
Hi Greg. I have a starter button that I repaired in the same fashion as the one that I posted about earlier in this thread. If you would like to...
I still have an '86 VF500F engine, was running when removed from the bike. I intended to use the heads on my '85, now sold, so I have no use for...
I made a rare mistake LOL! The rear carbs on the '84 take 102 mains, not 105s as I stated. For clarity.... Fronts: 105 mains, 38 pilots Rears:...
I would look at the carbs 1st. RTV on the float bowl seals would lead one to believe that there are probably pieces of RTV inside the bowls and...
Hated to see it go, but I have sold my '85 VF500F. I have an '86 engine & carbs I would like to see go to a good home, take a look in the...
I'm pretty sure that all the early VFs used the same pulse generator. Go to an OEM parts site and check the fiches for the pulse generator to see...
:thumbsup:
For cheap, Duplicolor Scratch Fix Ford Sonic Blue FM 378 is very close to the Aleutian Blue. GM Arctic White is very close to the Shasta White....
The blue is Candy Aleutian Blue Honda code PB127. The red is Fighting Red Honda code R134. The white is Shasta White Honda code NH138. They are...
Worth checking....correct clearance is very important for proper performance and long valve train life. You state that there is no undesirable...
I like to keep things simple. I rotate the engine placing the heel of the cam lobe against the rocker, use the two feeler method. I bought my 500...
On my 500, the vacuum line from the fuel valve goes to the vacuum port on the LH carburetor. The other nipple on the fuel valve is an air vent,...
Agree that the problem is fuel delivery. 1st, check fuel flow from the petcock. If that is OK, turn on the petcock, wait a few minutes, then open...
Gas in the oil???
I have a perfectly running '86 engine that suffers from the same problem. I plan to use Permatex high heat epoxy to bond the piece back on and see...
When I bought my '85 with 14K on it, been sitting for a few years, it needed the carbs cleaned & some 0-rings replaced. Followed the FSM, carbs...
I've tried all the cereal boxes, this one has the best quality cardboard. I toss the cereal however, it looks suspiciously like........well.....
Separate names with a comma.
