Will be changing the rear brake disk on a 2006 non ABS VFR and am looking for some recommendations for grease to use on the bearing, spline and...
Beautiful model, no reserve, dreaming is free. https://www.mecum.com/lots/1129126/1993-honda-vfr750r/?aa_id=642989-0
Looking to replace toasty connectors on battery harness. These come from the 30 amp fuse near the battery. Can anyone tell me the wire size or the...
Looking to replace the rear rotor and pads on my 2006 non ABS VFR and am considering aftermarket. Any experience or recommendations on brands?
Upper and Left (Clutch) Cowls from a 2006 Honda Interceptor with the Pearl Cosmic Black (color code NHA64P).They were in excellent condition,...
I am going to do a starter valve sync soon and have read different approaches as to whether the MAP electrical connector and it's vacuum hose...
I have a 2006 VFR with 8,800 miles on it. Today while riding home stopped at a light the engine began to run rough and the idle dropped below 1000...
Would using something like this (picture attached) to jump start the bike be dangerous on a 6th gen? It is a 500 amp with 1000 amp peak jump...
I am looking for some Go Pro mounting suggestions for a 6th gen. I want it more for safety and so am looking for forward viewing. Does anyone have...
Has anyone done an upgrade to the 30 amp. fuse near the battery pictured below? It is a known problem and tends to get crispy wires and a melted...
I am going to do a synch using a carbtune on my 2006 VFR and have a question. Do you connect the hoses ( restrictors installed) coming from the...
I was beginning to change my CCTs beginning with the rear one when I hit a snag. I checked the winding procedure to retract the tensioner with the...
On a 6th Gen, concerning the idle adjustment cable that is on the lower right side, in what direction to you turn the screw or knob to DECREASE...
My 06 Vtec has been idiling at 1200+ when I start it but goes to and stays at around 1500 once it warms up. I have tried to adjust via the...
Going to install new Honda OEM clutch friction and plates on my 2006 and have 2 questions. 1. The clutch plates (metal, 7 of them) have a...
Just want to share something I found. I recently changed my chain and rather than buy a quality chain tool set that maybe would be used once or...
I am inspecting the clutch on my 06 non ABS VFR. I have removed the Crankcase cover and as shown in the included Illustration have already removed...
Separate names with a comma.
