When pulling the clutch lever in on my 84 vf1000 it makes a knocking noise on the clutch cover and can be felt with the hand. At first I just...
Hi all, not sure if this has been covered on this site or not but when installing my cams on my vf1000 1984 I just couldn't get the timing set up...
The oil is leaking on the outside of the seal and not round the slider, they are pattern seals so Perhaps I should try original before doing...
Hi all, I need to replace my left fork leg because I suspect the lower is mis-shapen because I can't get it oil tight, have replaced lower bush,...
Well I have had my starter motor re-built at a cost of £47 and for the first time in 7 years my bike rumbled into life:biggrin: . Now I know it...
Ok, having received a manual for the bike I have been able to test the starter and the armature is at fault, I am looking into having the starter...
Hi all, tried to start my bike for the first time as have only just got battery. Before this I had bench tested the starter with a car battery and...
Thanks for that, I am waiting for a service manual to come through so will check that out and increase the gap as you say. I did take the tops off...
I took mine from the fact I work in the woods and do a bit of wood turning and the like. Some great little tales on this thread, good reading:smile:
Have seen one or two in the uk, there is one being broken on the uk ebay.
Hi all, just bought vf1000 1984 to do up. I heard that honda released up-dated valve clearances to help combat the cam problem, is this worth...
Separate names with a comma.
