needle shimming, I mean I have turned my fuel screws to 3.25 turns out and added one small shim under my needles on my wonderful 96 VFR...
I just slid my stock bars up and tightened them down (after removing the stopper rings on the fork) Instant helibars
The proof is in the pudding, although I do not fully understand the function of these air "jets", the bike is now running very well. It was a...
Thanks to the guys who insisted I look closer at my carbs. I am cautiously optimistic...i found that a tiny backflow valve next to the air jets in...
I have tested with known good coils and plug wire/cap combo's. all of the above, both the original and the known good units spark fine with the...
In my other thread I said my cali bike was much slower than my 49 stater...it was and it is I have been investigating for days and have noticed...
My bike is dropping the front left cyl....thus the pathetic performance Do I own california an apology for the mean stuff I have said concerning...
It is not a matter of keeping up, this is a streetbike, not a racing machine. i would at least like the bike to make power similar to my 49 state...
I thought the VFR was a grown up, mature riders bike. so far the only maturity I have seen in this thread is that hot piece of senior citizen ass...
hey , you are sounding like a tard. has it not yet dawned on you that this topic may be a tad tongue in cheek?
my other VFR (the 49 stater)is a 1994 model
I am about an hour south of the blue ridge parkway....an hour west of Charlotte I am not condemning the poor bike, merely stating that it has had...
cow manure?
Separate names with a comma.
