UK model but should be same as your the non cali one. Hope this helps. Honda VFR 750 FG 1986
Have you checked valve clearances, also test for compression on each cylinder. Ht leads are these ok. Inlet manifold rubbers do not sit properly...
Righto got that, thank you very much. Fantastic views by the way.
Another thing, it could be that your spark unit (30400-ML7-601) is fubared. Can you obtain another unit to test this hypothesis. And have you...
Hows things with the bike, hope u getting some miles and smiles under your belt. How did u get the speedo drive to stop turning as the vtr forks...
Just a thought jesii, have you checked your earth wires & connections
Fantastic job there 2Wheel. Just wondering how much fork travel you have.,from full extension (top of rubber seal) to underside of bottom yoke....
Spot on with tyre sizes. Going with 120x70 on the front, will keep your speedometer reading (accurate) as per the original 16 inch tyre. As the...
Agreed either will fit they are identical.
Hello mate, I think you will find that the inlet rubbers from an Honda VFR 750 FG or the VFR 700 USA version (part no.16211-ML7-000) will fit...
Righto chaps, OE pump packed up finally, new OE pump is about £180, no way was I paying that so went aftermarket. Decided to renew all fuel lines...
This I believe started it all for the VFR, Enjoy. YouTube - 1986 Transatlantic Challenge Trophy Races Bad spelling, should be Transatlantic...
Have you by any chance measured these yet. Would be very gratefull to you if you would give me dimensions please. Cheers
Separate names with a comma.
