A little heat from a hair dryer can work wonders to soften up the old boots and get the carbs off. But its not a cure. Then buy a new set off...
If you really want a permanent and weatherproof join then best use Marine heat shrink - it has a glue layer inside which makes the repair...
You are welcome. I wanted one I could tie to someting with a bit of wire. Definitely not hand-held. Both my hands were too busy guiding and...
I simply looked for "digital tachometer" on Amazon and Ebay and chose a small unit. Here is the one I used. It is still available on Amazon and...
Snappier throttle response, smoother acceleration and greatly reduced initial response lag. You know, the usual stuff. I don't know if it makes...
Actually the top NOTE on page 6-22 and 6-23 says to synch' the throttles first and then see to the mixture screws. I ended up doing both as a...
Have you read "The Drill"? It's a sticky thread at the top of the Mechanics Garage forum. Read it all, it will be worth it. After reading that...
I suspect what you want is the opposite version of this. If you have a chat with the vendor they may be able to create one for you......
For that snatchy clutch, its probably dried crud in the slave partially jamming the piston. Very common. Pretty easy to fix with a rebuild kit...
If you look at various parts suppliers such as https://www.cmsnl.com/honda-vfr750_model323/ you should be able to identify the exact...
Here you go…. https://nrp-carbs.co.uk/shop/index.php?route=product/product&product_id=5088 Wrong country, so you’d have to pay shipping, but...
I use genuine brass circular (flat, disk shaped) brushes mounted in a dremel extension. I needed the extension to get through the far side of...
Maybe too late for this but... Pop out all the spark plugs and spray a healthy dose of Fogging Oil into the bores. Do this twice over two days and...
I use AS3 hoses on my Gen4 750. They seemed far better than the stock hoses. A fair bit cheaper than Samco. I had to cut down one of the...
Put a blob of grease into each of the top groves. In the next step it will melt down to a light runny oil and act like easing oil. Pen' oil will...
Separate names with a comma.
