Recent Content by PLCBithead

  1. PLCBithead
    Post

    Best way Remove old hand grips?

    Thanks Jason Do I use grip glue to install the new ones or just hair spray?
    Post by: PLCBithead, Aug 14, 2007 in forum: General VFR Discussions
  2. PLCBithead
    Post

    Best way Remove old hand grips?

    Thanks Mello for the assist. I've been looking for a thread on this site and others with no success. You wouldn't think it would be that hard...
    Post by: PLCBithead, Aug 14, 2007 in forum: General VFR Discussions
  3. PLCBithead
    Post

    Best way Remove old hand grips?

    Oops! Item 3 should read "remove adhesive" not dahesive... Fat Fingures typo.
    Post by: PLCBithead, Aug 14, 2007 in forum: General VFR Discussions
  4. PLCBithead
    Thread

    Best way Remove old hand grips?

    Hello All; What are some of the better ways to remove old handgrips? 1. Cut them off? 2. Rip them off with a pair of pliers? 3. How...
    Thread by: PLCBithead, Aug 14, 2007, 12 replies, in forum: General VFR Discussions
  5. PLCBithead
    Post

    windscreen preference?

    Hello Again FullCircle Got my ZG Sport Touring windshield. Tried it and I don't like it. Poor fit quality compared to OEM and much thinner than...
    Post by: PLCBithead, Jun 18, 2007 in forum: Mechanics Garage
  6. PLCBithead
    Post

    Vtec Maintenance

    I had my 5th gen done at 31,500 and it cost me about $400 :mad: . Only one valve needed any adjustment and then only by .001. I was not sure if...
    Post by: PLCBithead, Jun 7, 2007 in forum: 6th Generation 2002-2013
  7. PLCBithead
    Post

    windscreen preference?

    Hello FullCircle; I just ordered a ZGST. I should have in a week or two, I'll let u know
    Post by: PLCBithead, Jun 6, 2007 in forum: Mechanics Garage
  8. PLCBithead
    Post

    Coolant in oil

    Ouch! Coolant in the oil is never good. You're not running it that way are you? If so you will damage engine bearings as coolant is a poor...
    Post by: PLCBithead, Jun 5, 2007 in forum: Mechanics Garage
  9. PLCBithead
    Post

    Aching shoulders in the wind...

    Thanks for the feedback Grinder. I did just place an order for the ZG sport touring windshield and I do have a Throttlemeister. I might try the...
    Post by: PLCBithead, Jun 4, 2007 in forum: General VFR Discussions
  10. PLCBithead
    Post

    Repeated Blown Headlight Fuse

    Hello Hawk; This should be covered under warranty, and if its not I would climb the ladder at Honda untill you get satisfaction. No circuits...
    Post by: PLCBithead, Jun 4, 2007 in forum: General VFR Discussions
  11. PLCBithead
    Post

    Aching shoulders in the wind...

    Thanks Elizilla; It has not been cold during these longer rides, and I don't think I have a death grip on the bars. My evidence of this would...
    Post by: PLCBithead, May 29, 2007 in forum: General VFR Discussions
  12. PLCBithead
    Post

    Aching shoulders in the wind...

    JJake, I could not have phrased that better. The wind hits me square in the shoulders. I thought I was the only one
    Post by: PLCBithead, May 17, 2007 in forum: General VFR Discussions
  13. PLCBithead
    Post

    Aching shoulders in the wind...

    Original Thread Poster Well Thanks to all who have replied. I suspect that those of you who are iron butts could also ride just about any bike...
    Post by: PLCBithead, May 17, 2007 in forum: General VFR Discussions
  14. PLCBithead
    Post

    this is starting to get ridiculous

    Glad you survived the crash. Now, you wouldn't get into a plane with a pilot who was learning to fly without formal training, would you? Of...
    Post by: PLCBithead, May 17, 2007 in forum: General VFR Discussions