Interesting thread...thanks for info...and they look very cool and bang up to date
EBC?
USD forks look awesome but takes time, cash and the solving of a few engineering problems which need competency. For now I fitted a Nitron street...
At 20k I would hope not...as I said, it's just the start of the normal build up over time as you would expect. It's all sparkly clean other than...
Has anyone blanked off the hole rear right in the air box and fitted a filter to the rear cylinder cover or the black rubber pipe? I only ask as...
Rake and trail cannot be adjusted unless you push the stanchions up through the yokes.
Holy crap, that was a close call...I have tried to stave this off by fitting a mosfet reg/rec and keeping an eye on the connector
Hey, thanks for the reply Hellfish. Nice rig you have there and clean too. I replaced the M6x55 screw that mounts the pillion footrest with a...
Gotcha! When you have it in your hand it makes sense! Install went fine except that the M6x66? screw that that acts as the footrest pivot is not...
Has anyone fitted a Givi PL257 side bag rack? I have the FZ257 Mono Rack installed already and E22n side bags coming soon, so if anyone has...
Grinding shims takes the hardened surface off so the go out of adjustment loads quicker
Yep, I greased all needle rollers when I pulled the swing arm to re-grease its bearings but it's more the sealed bearings that I'm interested in.
Hi all, Has anyone replaced any or all of the bearings in the sprocket carrier and stub axle assemblies? Would just like any experiences...
Separate names with a comma.
