I don't recall needing to do that when I bled mine back around January; I bled from the calipers using my Mityvac and all went smoothly.
Heli-bars are produced a short distance from my home. The local Honda dealer's one VFR is on loan for a few days to Heli so they can use it as a...
It sounds as though you have pinpointed the problem; I would just install the fresh o-ring without the aftermarket sealant and see if it leaks. I...
Yes, And that's what is puzzling me. The later gens are also at the higher torque spec and I can't figure out why the 4th Gen would be the only...
Double posted in error Hi, Yesterday on my 4th Gen I removed my front wheel for a tire change and when done torqued the axle...
Hi, Yesterday on my 4th Gen I removed my front wheel for a tire change and when done torqued the axle bolt to 43 lbs. Afterwards, I noticed...
Could be lots of things: a bad thermostat, a faulty radiator cap, a bad water pump, a collapsed hose, etc. You need to do a little...
I think that as long as you have enough material showing to allow the risers to get a good purchase you should be fine. BTW, that 3/4 inch rise...
I've had them on 3 of my bikes so far (including my '04) and have never had a problem with any of them. I don't think the finishing caps make any...
I want to congratulate you. It's very refreshing to hear someone set aside completely their ego and objectively appraise their own skill level....
No prob; we've all been there.
Have u checked the starter teeth and the solenoid? A missing tooth on the starter. will have the same effect.
Separate names with a comma.
