[ATTACH] [ATTACH] [ATTACH]
My exhaust is beaten and rotted. The tip that connects to the muffler almost gone , and already have some welding work done in the past , so I...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] After some scaring issue - Rear axle loose nut I decided to go deeper and check and clean...
I agree , and when I have disassembled this , there was some dry brown paste that seemed to be 29 yo stock . So some grease or paste was there...
Besides the ST1100 is a drive shaft model , it makes sense to protect those connection's with greaze/paste for various hazards.
Awesome. Thx for the golden tip ;)
The strange is that the rapair manual don't say to use some paste/grease. But it should.
Unfortunately I only have some lithium enriched with molybdenum grease from PETRONAS. Don't know if I can use this instead.
Everything disassembled and seems all good . Bearings still good , no noise , will give it a good clean and grease everything again and put back...
It was wrong on mine. Damm.
[ATTACH] Can someone tell me if the conical washer #part 25, that is next to the axle nut , does the rounder side points to inside or outside?...
Tomorrow is my day off and will disassemble it and take pictures of the process as usual. No worries. :)
I need to inspect just to be sure. I can't sleep well if don't. Also I will take the opportunity to grease those needle bearing.
Separate names with a comma.
