Sounds reasonable but to be honest, I had to do so much work to get in there and access the clamps. You don't want to take off your throttle body...
Yes i did but it was a massive pain in the ass. I discovered it wasn't the water pump but some of the hoses connecting to the thermostat housing...
Mine is a 1999. 5th Gen. Corkey , I thought you had replaced the thermostat on yours which required you to take tank , air housing and throttle...
Corkey i just created a new post because there are some electrical connectors that I cannot figure out after i put the throttle body and air...
I just replaced thermostat and hoses in my VFR and put the throttle body and Air Cleaner housing back together but I now have some connectors I...
Corkey thanks for the response and suggestion , unfortunately i already had the hoses off before i spotted the Dot markings when the new ones...
A couple of quick follow up questions , what are the red and white dots on the hoses, see attached image. I couldn't see any reference in the...
I am looking to replace and having real difficulty identifying the correct part numbers and hoses on Bike bandit.com. Actually if anyone knows a...
Thanks NormK , So no other possible cause? There is no seal I can replace instead of the whole watere pump unit or is it standard to assume if...
I have noticed a leak in my 5th gen from the same hole as you show in the picture post # 4 above. Right side lower engine block. What is this...
Sorry for the late responses. The bike has 45K . The battery is over 2 years old but tested ok . ( i just went through an full RR/Stator/ battery...
Rjgti , thanks for the suggestion, why those? I just replaced melted connector harness and upgraded some wiring and now the electrical charging...
It feel like this is either an electrical connection impacted at temperature or some main controller. I don't even know where to start. Anyone got...
Separate names with a comma.
