Outside after polishing. [ATTACH] Inside the empty tank. [ATTACH] Close up of inside, a little rust has formed in the empty tank. I had a...
Hi all, I eventually got through this project. The key was to use heat. After a first baking at 250F, the coating, which had slid mostly to the...
Jman, I'm a little confused. You say you figured it out, and that means the problem was the float valves weren't seating, but that was on a...
I think it was the POR-15 instructions for removing other coatings that said duct tape would not be affected. In fact, the stripper dissolves...
Well, I went the meth/chloride route and I regret it. Initially I was just duct taping over the openings. What happens is that the chemical...
There is nothing worse than a worthless thread. Let's see if I can make it worthy with a pic. Me in the CT United ride a couple of weekends ago....
Hello to you too, ridervfr. Do you always introduce yourself this way?
That's my situation, cleaning the rust out, which leaves the metal vulnerable to more rusting. I have used POR-15 three times successfully. But...
Billy, Tanks for the reply. Did that test with some of the coating that easily peeled right off the inside of the fill hole. (Suggests a...
Thanks! Is that the 1988? Or the 1990? I only know it's not the '89.
You mean because of the tubes and other stuff going on inside there? This is my concern. Although in a sense they are easier than other tanks...
A peek at what's inside
I covered the outside with duct tape to protect the paint from stripper
Hi guys, I have a 1987 VFR700F that I bought recently on eBay. The bike was in riding condition, but there are a few things I want to check...
Separate names with a comma.
