I also have the lady gunfighter seat, fits with not much problem. I trimmed a little bit of foam of the top back then reattathced the leather....
cant wait to see it finished. one of my favorite classic sport bikes.
+1 for for down shifting on decel to stop or slow. IMO bike should always be in the correct gear to accelerate if needed without having to put...
if they all mic out the same, consider weighing each set piston, rod and pin and shaving metal of (you will see where it was done at the factory...
4th gens are know to be the best handling of the vfr's and were modeled after the NR750 (oval piston wonder bike), aftermarket parts i find are...
nice looking bike, congrats and welcome to the forum. i might shy away from LED's the are can be supper bright but very directional, in that way...
I have the airtech on mine with Corbin seat. You make a great point, the way around it is to peel the back part of the seat up and trim down the...
Well I am happy to see that you were in relatable condition, I am fairly experienced with that neat card you speak off, it is a wonderful thing. I...
Actualy after I got the solo seat cowl 3/4 of the way done I saw the price of the airtech cowl and decided to just go with it. With an extra layer...
I got the airtech solo cowl and was relatively happy. Fitment was good, was a little flimsy for my liking but that was solved quickly with...
Hahaha. I believe I remember you. Yeah It has been done for about 3 months, got it out for a ride in October on a nice day the brought it back in...
Thanks every one nice to hear. I was pleased with the thurn body work, very solid fit with minimal fitting. A few spots in the jel coat needed a...
it dose not sound like CDI to me, they are rare to go(although mine went) but when they go they usually internally short and you will be blowing...
check the connector under the tank, use DMM on both sides, checking for switch actuation on the tank side, and that you don't have an open circuit...
finaly finished well it has been a while, since i have posted up anything on the project. Other than the final wet sand and polish the bike is...
Separate names with a comma.
