I hear ya dude, admit she’s a top heavy one, so replaced exhaust system helped some and only carry couple gal of petro ie riding the Dragon, I’m...
Wish had some pics myself taking this on, but I assure you once you get caliper apart as OZ describes its somewhat obvious where you need to...
Like when the Corvette stopped using fold down headlights, when the VFR800 stopped exiting twin pipes out the back she lost some of the sex appeal...
I did something similar, was not as hard as I was afraid, and blocked second inlet as OZ VFR did. F4i rear master cylinder did the trick also,...
I installed the wing, approx 6” tall, only helps a little, no matter what angle I adjust legs or tilt of it, for the quiet I think you and I are...
Chrome-Less Beauty by CaptGarvin posted Nov 3, 2007 For what it’s worth, I considered bags and trunk, but ended up getting just the trunk mount...
Early models of the vfr800 had problems with insufficient load capacity of the wiring harness, I didn’t get the notice until after I fried the...
OK, I’ll make it $.08 And I’ll throw in one glove but that’s my limit. Actually wish you luck, a working bike for a penny is priceless. I will...
My 2002 non abs has bleeder on top of rear pcv, as the front pcv on left side. Rear is hell to engage. In addition to taking off rear caliper for...
Just got the Galfer Braided lines and have decided to bypass linked system for now, but need to come up with way to include the left front middle...
Fixing to replace my clutch on 2002, but have always had the factory service and parts manual, you should be able to find one online, but will...
Best I can tell you is unplug all wiring harness junctions, put new fuses in and connect back one section at a time, checking fuses each time,...
Had similar problem, suspect mechanic installing front tire put pressure on the rotor removing tire. Was barely noticeable but new rotors and pads...
Without the wiring diagram from the service manual knowing what other components, or what wires go to what without a headache search, and if your...
Separate names with a comma.
