How do those who have repaired or modified frames decide on which alloy of welding rod to use?
Did the FI light turn on or flash during your rides before the problem was diagnosed? The pressure regulator I can understand, as it may have...
The cold and warm idle speeds are too low, as they should be around 2000rpm & 1200rpm respectively. If the idle speed adjuster is stiff it may be...
Does anyone know which aluminum alloys Honda uses for its frame and swingarm extrusions and castings?
Since the starter valves for cylinders 2, 3, 4 (adjustable) were all registering very low vacuum with respect to cylinder 1 (factory set), I...
Removed the throttle body, checked all vacuum connections, lubricated the starter valves, and replaced the cold start wax unit just in case....
Thanks for the links John, although I've checked the things mentioned. I'm pretty sure the problem is not a trapped air bubble near the fast idle...
I had to remove and clean the fast idle wax unit on my bike after a period of modifications with no riding. It had stuck in its bore and would...
On my 5th generation VFR, I have noticed that the inside of the fairing has been contacting the lower leading edge of the right side/clutch engine...
I have considered that option and have been searching for an RC45 rear axle, but it seems like a search for the Holy Grail, they are extremely...
"...but the arrow that says front and points, points forward now..." Which arrow are you referring to? All I see are the small arrows near the...
You could turn the rim around as a temporary solution, but I agree that it is preferable to remove and remount the tire. The wheel is directional...
Separate names with a comma.
