Hey Lint, I bought the HOT CAM kit when I did this job last year. (3-5 of like 6 sizes) I used a lot of one size, but unless you're really...
Take BadBilly's advice. DIY. It's all over the Tube of You. I had a similar problem on my '98. I ended up re-upholstering it myself for cheap. I...
Was the choke open in that film? Was the engine warm? I'm afraid your knowledge may be far deeper than my own but my first thought is to run the...
If your talking about the starter valve sync, I didn't mess with it. I didn't have a good reason to do so. Idle air adjustment was enough fine...
I needed 9 shims so I got this: https://www.amazon.com/Hot-Cams-HCSHIM04-7-48mm-1-50-1-75mm/dp/B000GTSA7U Its a refill for the kit for 1.50-1.75...
Sorry for the delay. I went back to triple check timing and realized what had happened. Ignition coils 1/3 were switched. Apparently the previous...
Los Feliz/Glendale. I'll ride anytime. I usually ride the 2, but I suspect conditions are rough up there now. Post a ride, and I'll show.
Thanks for the help everyone. FWIW the bike is a '98. Update: I picked up a timing gun before I started this morning. Timing is correct, cams are...
I've had my bike a couple years and it was time to check the valves... 9 were out, and I replaced the shims. Things went wrong when I realized my...
Old thread, but useful even today. Thanks Joey! I'm halfway through the job and I think I need 7 shims... Anyone know of a Los Angeles area Honda...
Separate names with a comma.
